This week I have a completed project to show though it’s scope is somewhat less… ambitious than usual.
This time I cut, inked and mounted a wearable paper cut. Overall the process was mostly the same, except smaller, and a lot harder since I’m on cold medicine.
This is the full cut before being put into the locket. I had to trim the edges so it would fit so the final product is a little different but mostly represented since the matting of the locket cuts into the image anyhow.
And here’s the finished product. Lets see some angles.
And just the shadow.
It didn’t take too long to produce the whole thing, though making them smaller doesn’t exactly equal out that they are easier. I’ll probably make a few more designs that deviate from this one.
-Eric
That turned out fantastic!
LikeLike
Very cool!
LikeLike